View Full Version : GEAR NOB
went to reno and asked for a gear nob for the 16v but he said there are two differant deepths for the gear nob so i said i will have a williams one..
he said the same again..IS THIS RIGHT? also said cut if off to find out..
do not want to cut it off then be without a nob for coulpe of days :roll: :lol:
Swervin_Mervin
28-09-2005, 16:42
Looking at dialogies it looks like one specifies a flange lift of 34mm and the other is none specific, if that helps! :?
so there is just one size then?
Swervin_Mervin
29-09-2005, 10:47
No, there's two. You would have to hack the old one off I'm afraid. It looks like the measurement is taken from the top of the stick to the point where the flange (for reverse) starts.
Dancliovalver
29-09-2005, 10:49
hey will that diologies thing tell u how much phase 2 "16v" bumpsrip badges cost and what the part number is?
sorry to steal ur thread by the way :wink:
Swervin_Mervin
29-09-2005, 10:51
It's an old copy mate so it would only give a ball park figure.
Dancliovalver
29-09-2005, 10:54
sounds good to me
just ordered one they are all same size.. nob at reno confusing everything said there is too sizes
cost 19.67 with vat
fit it and you get no glue
so i fit it with super steel. it is going no were
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.