FAO Winston

[Martin]

Alright pal...how easy was it to fit your buckets with sidemounts? Were they bolted direct to the floor?...I've been told I would need plates welding in... cheers

[Mark_Ritchspeed]

Ideally you should weld plates in to disperse the weight better. The Clio floor is very thin like most cars and likely to split without proper plates, if the mounts are just bolted through the floor.

[Martin]

cheers mark

[Winston]

I never got round to welding metal in for them :oops:

Was going to weld in some 2" square tube, to rase them up a bit......as they where batty riding lol

[Lunner]

Mine are bolted through the strengthened mounting points for the std runners on the door side, otyher side they are simply reinforced wiht large washers underneath, keep meaning to get my home made runners welded to teh raised basra at some point, shoud make then solid as

[Lunner]

http://lunner.co.uk/RSi/Seats/slides/CIMG1043.JPG

http://lunner.co.uk/RSi/Seats/slides/CIMG1044.JPG

[Winston]

I used large washers to lol

[Slithers]

http://lunner.co.uk/RSi/Seats/slides/CIMG1043.JPG

http://lunner.co.uk/RSi/Seats/slides/CIMG1044.JPG

Why did you need an oil filter to change the seats? :lol:

[Justin..]

^^ lol

[Lunner]

Becasue i brought the oil filter about a week before and it had been rattling around my car and i hadn't got around to changing the oil yet....my car is a dumping ground for absoloutly everything

[Slithers]

Becasue i brought the oil filter about a week before and it had been rattling around my car and i hadn't got around to changing the oil yet....my car is a dumping ground for absoloutly everything

Furry muff, what make socket set is that btw is it draper?

[Lunner]

Yup, Draper Expert, working for a shop that stocks Draper tack, i get everything at cost :D

Draper Expert are the only bits worth getting, Draper value is like blue tac, and normal Draper is ok, but i tend to break it after a few months, can't fault anythign draper expert i've had

[Fred]

doesn't look FIA approved to me LOL