W1LL14M5
02-03-2017, 20:03
Ok....still no spark. I've:
1) removed cobra alarm immobiliser
2) replaced coil
3) replaced rotor arm n dizzy cap
4) replaced ignition module
5) replaced flywheel sensor.
I've gone thru all the diagnostic steps as prescribed in the dialogsys guide, but seems the signal from the flywheel sensor, which feeds back thru the ecu, is not getting to the ignition module....therefore no ht being generated.
Any suggestions?
Sent from my SM-G920I using Tapatalk
1) removed cobra alarm immobiliser
2) replaced coil
3) replaced rotor arm n dizzy cap
4) replaced ignition module
5) replaced flywheel sensor.
I've gone thru all the diagnostic steps as prescribed in the dialogsys guide, but seems the signal from the flywheel sensor, which feeds back thru the ecu, is not getting to the ignition module....therefore no ht being generated.
Any suggestions?
Sent from my SM-G920I using Tapatalk