Clio valver breaking

[will3232]

Have just bought a Clio valver to cut the arch out of to repair my williams. There were still loads of parts on the car which I have now started to take off.

I have removed so far:
2 x seat rails
wiper linkage and motor
blower motor
idle control valve
throttle body
both front hubs including calipers
pair of rear lights
ph2 bump strips
ignition barrel
dash support frame
heater matrix and retaining/distributor box
mongoose cat back (think this will fit a williams?)

there are a few more bits I haven't got around to listing yet such as the rear beam and quite a few other parts!! Please don't hesitate to message me if there is something in particular you are after and I will see if I have it :).

[AdzC]

PM sent

[Winters01]

PM Sent

[will3232]

Responded to all pms so far :)

[tomolad20]

Pm sent

[chayg]

pm sent mate.

[white16valver]

Poor ol' valver! There must be a few going the way of Williams parts bins :(

[will3232]

Yeh unfortunately it is in so many parts and so much missing from it that it would be a nightmare to get her roadworthy again :(.

[Matt24v]

Hi mate, whats the rear of the car like rot wise?

[will3232]

Not too bad, depending on what you're after?

[AdzC]

Will I haven't heard back on the parts I enquirer about

[Matt24v]

My 3 is rotton on rear panel so could do with a good chunk of donor panels lol

[y0z2a]

Hi,

Do you have a complete keyset and Lockset & IR Sensor for remote locking / unlocking?

/y0z

[will3232]

Not sure about the sensor but pretty sure I have the rest mate will have a look over the weekend

[Crossers]

Do you have the rigid green brake lines from front driver & passenger side (from the arch to the master cylinder and travel through the engine bay?).

Paul

[will3232]

Hi Paul, yes I'm pretty sure they are still there. Will check and get back to you :).

[Crossers]

Cheers

[garley561]

It doesn't have an electric sunroof, does it? I need everything apart from the surround in the roof

[Jamie9004]

Do you still have the car breaking as i know you started this abit back, after a front bumper?

[Vandella]

where abouts are you Jamie9004.. only I went n picked up a few bits of a chap on the facebook 1.8 clio valver owners and he had a front bumper he wanted rid of.. forgot the colour buts is dark and look in fairly good nick but has quick release clips on it.... would need a respray though..

his name was Nick.. and it was in Horsham.. if this helps you at all.. link below..

https://www.facebook.com/groups/552774358129615/923599584380422/?comment_id=923880527685661&notif_t=group_comment

[Jamie9004]

Thanks for the quick response , in Yorkshire but willing to travel for one if ok and willing to paint as well if it's the right price. I'm grateful for the link but got to wait to be accepted as its a closed Facebook group

[mack1]

Have just bought a Clio valver to cut the arch out of to repair my williams. There were still loads of parts on the car which I have now started to take off.

I have removed so far:
2 x seat rails
wiper linkage and motor
blower motor
idle control valve
throttle body
both front hubs including calipers
pair of rear lights
ph2 bump strips
ignition barrel
dash support frame
heater matrix and retaining/distributor box
mongoose cat back (think this will fit a williams?)

there are a few more bits I haven't got around to listing yet such as the rear beam and quite a few other parts!! Please don't hesitate to message me if there is something in particular you are after and I will see if I have it :).

I am looking for Williams 2 wing mirrors . There electric. What colour is your valves. Will yours match. If so could you pm and send some photos.
Thanks Mark

[Timmy C]

Hi I know this post is a bit old now but I'm looking for a fuel sender unit and also passenger side electric window switch. Also the do you still have the magnex exhaust? Are these items still available??

[will3232]

What sender unit are you after as it appears a series 1 sender unit is different to the rest? I no longer have the magnet although I have another stainless system from a Williams. I'd imagine I have a passenger window switch did you want the one from the passenger door or the drivers door?

[Timmy C]

Hi the sender unit I currently have has the following codes on it - 'Bitron made in Italy' 7700829318B, 3 bar - 550070, >POM< '047' inside a diamond, is the one you have the same?

What is the exhaust exactly? Yes passenger (N/S) electric window switch - the one that goes in the passengers door - Obviously needs to be working.

Let me know, cheers

[geraltzrusa]

Hello buddy
Not sure if youre still breaking ,im after heat shields under bonnet one and underneath near petrol tank and after a working weight distributor from rear underneath. Regards