1995clio16v
22-06-2011, 19:32
Think im almost 100% clued up on this now. Doin this Saturday. Good guide on Retro Renault
Just two questions. Hoping im sounding clear!
Ok
1 - make a mark where the hole punched hole is on the bar im going to extract
2 - Withdraw bar
3 - Going to try it by 1 spline to start off with
4 - My question...? Am I correct in sayining when I move it one spline along/round, i re-insert bar back in having moved the bar round CLOCKWISE by x1 spline?
Just two questions. Hoping im sounding clear!
Ok
1 - make a mark where the hole punched hole is on the bar im going to extract
2 - Withdraw bar
3 - Going to try it by 1 spline to start off with
4 - My question...? Am I correct in sayining when I move it one spline along/round, i re-insert bar back in having moved the bar round CLOCKWISE by x1 spline?