View Full Version : Engine Stand
Can anyone recommend an engine stand suitable for our glorious F7R powerplant please? I seem to have engines building up around my feet and want to keep one off the ground to work on.
Cheers!
machine mart mate the cheap 3 legged one i have used and its fine. irrc it was £30
Damn no edit button. This is the one i have and is fine.
http://www.machinemart.co.uk/shop/product/details/ces-500a-engine-stand/path/workshop-cranes-engine-stands
Ahh, yes. I had seen that one but was not sure if it was big enough :) Thanks!
does this mean I can finally sell that big lump sitting in the corner of the garage :P
I have sourced a newly built engine, yes ;)
good stuff wobba..take her handy :wink:
MatBrown
14-01-2011, 17:21
I have sourced a newly built engine, yes ;)
Matty's?
How much?
Mat.
Yea. It's a barely run in 12.5:1 F7R700 block with ported head, all built by Nick Hill with forged steel Wossner internals, oversized rings and new bearings and pump. Yes.
Depending on how my APD head looks when I crack my engine open depends on whether I will use the Hillpower or APD head. Both are Megane 714 with bigger valves.
After fitting I want to rebuild the current Megane bottom end. I think it may only need new rings, but I'll check.
Quite a bit of work to do, but I am excited as it will push me over 200 bhp I think. Should be a fun summer!
While you have both heads off get them flow tested, then just use the better one, i have the machinemart engine stand with the 2 legs, U shaped, worked well for me, not needed now £20 and its yours.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.