View Full Version : downpipe
lads whats the default position for this thing? is there a bracket that holds it in place? maybe I lost one on the rebuild.
any sealant needed between fanifold and downpipe needed?
thanks,
fab.
katbloke
21-11-2010, 20:45
no sealant its a wirey compression ring i think
oki dokey then..think the exhaust is pulling it off center. will have another butchers at it tomorrow.
stevie_b
21-11-2010, 22:33
There should be a tapered 'fire ring' that sits around the end of the manifold part that the downpipe then bolts up against and creates a decent seal without the need for any paste, etc. It should just be a case of tightening the mounting bolts against the springs that are there.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.