PDA

View Full Version : Various parts - 16v/Williams



bison3
09-10-2010, 13:06
Williams Magnex centre section and backbox - £40
Radiator fan (x2) - £15 each
16v shocks and springs - £40
449 passenger door, ok condition but not amazing - £10
449 tailgate (x2), one with 449 colour coded spoiler. OK condition - £15
Inlet manifold with TB - £15
PS reservoir - £5
16v clocks, 1 on 121k, the other on 127k - £10 each
16v oil dials - £10
Heater dials - £5
Stereo cover - £5
PH1 16v dash top, good condition - £15
Various interior plastics etc - £5
Clear side repeaters - £10
PH1 wing trim - £10
Lockwood 16v chrome kick plates/ sill plates - £5
Fresh primed/sprayed black scuttle panel (x2) - £10 each
Headlights - £10 per set
449 door, quite rough condition - £5
Steering column - £15
16v downpipe with lambda - £20
PH1 ECU - £30
PH2 ECU - £20
Gunner 180 chip, brand new, un-used and still wrapped with carrier - £35
Roof strips - £5
Power steering pipes, both types - £10 each
PS rack - £10
Aux fuel tank - £5
Rear light clusters - £10
Spark plug cover, good condition - £10
Silver gear knob with all screws - £5
16v starter motor (x2), both fully working - £15 each

Also have plenty of other various bits and bobs, especially bits of interior etc.

Pictures available upon request. All prices are for collection but postage is available at the extra cost.

redeye83
09-10-2010, 14:44
where are you based?
can you send pics of the scuttle pannel pls
also have you got any arch linners, fog lights, bump strips and door linners
cheere
Tom

redeye83
09-10-2010, 14:48
sorry, all for a williams please

bison3
09-10-2010, 18:22
I am based in Northampton.

Will try to get pics of the scuttle tomorrow when it's light.

Don't have too much of the other stuff you're after though I'm afraid. I have 1 fog light (clear), rear drivers side bump strip and only 16v PH1 door cards.

Lee b
09-10-2010, 22:03
Pm sent
[/b]

cliokiz
11-10-2010, 12:32
PM'd

Dibs on exhaust.

Lee b
11-10-2010, 17:14
Already pm'd for exhaust
:)

bison3
11-10-2010, 21:48
Someone on c16v has already asked pics for the exhaust but if he doesn't take it then I will post it up here.

bison3
02-12-2010, 02:31
Bump - still have most of this stuff.

nuttynutter123
13-01-2011, 21:42
Hace you got a Williams ecu mate?

Geeky
14-01-2011, 10:17
Don't think I saw anyone asking for the 449 boot, is it still available? And is it rust free?

Thanks

redeye83
15-01-2011, 11:42
What stuff have you got left?