PDA

View Full Version : williams 1 no 335



benj
25-05-2010, 20:52
Nigh on everything available.

Part
Suspension
172 /Williams Wishbones - widetrack £50 each
172 Swivel Hubs £50 each
Gaz GHA coilover set, williams upper, 172 clamp new was £490, £440
Williams Front ARB - widetrack £50
Williams subframe modified to suit 172 radiator £75

Brakes
Master Cylinder non ABS £20
172 big brake kit, discs pads & calipers £80
Blue braided lines one has been loosely fitted but otherwise as new 172 length for BBK £40
Rear Brake Discs not fitted but been in the garage a while where £110 £80
172/ williams/ 16v Rear Calipers £60

Steering
172 rack with brand new track rod ends (nice pipework if your fitting F4R) £100
Williams rack £60

Transmission
172 (fit williams) driveshafts - widetrack £75 each
172 gearbox cable speedo mount fitted, also have electronic speedo sensor £230
172 Flywheel including clutch £80
williams Flywheel £25

Engine Mounts
upper cambelt engine mount £10
gearbox mount £10
dogbone mount £20
4th mount £30
Foxy 5th mount as new. £30

Cooling
Williams radiator not very old, new sensor. Was £120 -£60
Fan £15

Engine
F4R Complete head & bottom end
F4R Inlet Manifold £40
F4R Exhaust Manifold £30
F4R Throttle Body cable not fbw £45
F4R Pipercross Viper Air filter £100

Electrical
Williams Alternator - not very old at all. £50
F4R Loom wired to mk1. £50
F4R Starter Motor. £25
F4R Coil packs & leads. £25
Williams Clock set, including 3 guages 117k. £40

Other
Williams wheels, fresh from being refurbed & with michelins with loads of life left. £350
complete interior £220
shell ?
manual tension alternator set up including as new gates belt. £30
most other parts available, any pics can be supplied, also collection welcome and pm me if you want my contact details.

please also see my ad in parts for sale for F4R or widetrack items.

I've only had a quick search to price items, if you have a price in mind let me know.

for sale as i've just bought a house and wont get round to finishing the project.

cheers

Ben

sooty666
25-05-2010, 21:24
hi Ben can you tell me what body work is like, how much rust is on it. Cheers Ray

richy
25-05-2010, 21:30
looks a shame to break, could you not stick the wheels/bumper etc on and sell it as a rolling project, doesnt look like your far from done!

manxseven
25-05-2010, 21:37
Hi Ben,

Intersted in the Radiator, could you place up a picture please.
How old is 'not very old'?

Cheers,

Simon

ThRaXaIR
25-05-2010, 21:39
i was gunna say it looks in really good condition?

northy
25-05-2010, 22:33
what a shame to break it

But - dibs on wheels and door cards if they are mint

Danno
26-05-2010, 17:23
pm sent

benj
26-05-2010, 23:06
i was sure i'd replied to the above last night but it doesn't seem to be here now.

shell condition is fairly good, i have the v5 all in my name, some surface rust to the rear of the os sill the arch/sill/floor joint has seperated slightly and water has seeped in, this has left a hole a couple of mm wide and about 12 inches long, i have cut this out further to reveal a patch need welding to the inner sill, it needs a piece welding in to the rear of the sill but i have a piece of the right profile.

its been patched on the nsf inner wing near the gearbox earth.

Was cat C around 05 i found a shoddy repair to the osf wing, and door, and a repair panel has been welded on the OSF inner wing. hoping to get some pics when its light tomorrow. other wise the odd small ding but tidy.

couple of rust spots on the os rear arch, probably 3/4" dia max and a couple of them. dont think they have been repaired before.

ns arch and sill are really tidy, 1 small ding near the arch and thats it.

bottom of the doors are clean, bottom of the boot has rust in the usual place but would clean up ok.

hoping to get some pics when its light tomorrow.

dont think i'll get much interest or much back for it in its current state, need to recoup as much as possible the house needs a lot of work.

not sure on age, but as i say it doesn't look old. should be pic below.

it is a shame but hopefully all the parts will go to good homes. will keep you upto date with the wheels.

benj
27-05-2010, 19:26
not sure what happened to the rad pic. hopefully attached again now.

zeus
08-06-2010, 00:17
have u got the front bumper remaining? its sad 335 has been broke up mine is 336 still going strong mind :-)

vkosho
08-06-2010, 01:22
pmd

benj
08-06-2010, 14:03
i still have the front bumper, the lower mounts have been fibreglassed up by a previous owner. looks ok from the outside though.

free if you collect at somepoint soon :D

Gary16v
22-07-2010, 23:11
Ello fella how much for the door strips?? posted to da1

northy
23-07-2010, 07:53
what condition is the shell in ?

1995clio16v
11-08-2010, 23:23
You still got the ARB?

Want one I do...!

schakal
15-09-2010, 23:18
speedo cable !!!

does it work ,how much ?

phantome46
28-11-2010, 11:41
Do you have the auxiliary fuel pump which is mounted on the reserve fuel tank underneath? Is this in working order?

Thanks

Wobba
28-11-2010, 11:58
Willy 1's don't have aux fuel pumps ;)

longm10
23-02-2011, 22:03
Hi there

Do you have the following:

1. Interior time clock

2. Small plastic interior strip that holds the interior clock in place (sorry hard to describe!)

3. Front engine loom the electrical connector that fastens to the heater fan, I just need the black female connector!

If you can let me know how much for each that would be great

Thanks

benj
24-02-2011, 23:33
near enough all gone, only odd F7R engine parts remain i'm afraid.