Different types of

[Wobba]

Working on Leighanne's Willy 1 again...I happen to take off the steering wheel and straight away notice this one uses the different design column, wich uses a nyloc nut on the end of the column, which is a threaded section rather than flat.

Both my cars have had the big torx bolt that goes down inside the column. The other thing I think is different is the length of the splines. Hers seem shorter.

I happen to have The Nana's steering wheel in my possession and tried putting it on to see if it makes a difference and due to the apparent(?) shorter splines, the Nana steering wheel does not sit well with it, leaving too much play and visually not going down the column far enough as well.

[MatBrown]

Yeah, i seen a few, most tend to be the torx bolt.


Mat.

[richy]

the only ones i remember seeing with that type of column is the very early clios(ie J reg etc), but not 100% sure if that is how they should be, both my 1993 valver and my old w3 have columns with the torx head bolt!

[Justin..]

My K reg 1.2 had a nut and my M reg valver has a torx bolt

[katbloke]

I have a welded nut type column in my garage iirc

[Wobba]

So...it's normal but a rarity then ok. I can see in Diologys there is a nut option.

[vkosho]

i too have the nut column! :?

[ThRaXaIR]

not that my nuts are really of anyones interest on here...my willy 2 is indeed torx

[16v_paddy]

not that my nuts are really of anyones interest on here...my willy 2 is indeed torx

:shock: :lol: :lol:

The ph1 I broke had a proper bolt to hold the wheel on and mine did have a torx bolt, but I lost that & used the other bolt

[Matty86]

my J (086**** chassis number iirc) had a torx bit

my K (077***) has the bolt

bolt is much easier to work with imo :D

[2 live]

both of mine are nuts......literally ;)