PDA

View Full Version : Key problem



Itsme
06-04-2010, 12:33
The battery has gone flat on my key for the williams went out this morning and bought new ones.
They are in the right way round and the light comes on in the key but the car does not lock.
This is a bit of a problem on my car as there are no locks in the doors!
I have not used the car for about 6 months and it worked before any ideas?
Is there something I have to reset?

Phil

Wobba
06-04-2010, 13:38
Have you tested the lock button in the car?

Check the receiver connector, can get wet/corrode from leaks near the aerial.

Wobba
06-04-2010, 13:40
You sure the car battery is not like, super-dead? :lol:

robi1000
06-04-2010, 13:52
Super-dead... LOL!

Itsme
06-04-2010, 13:57
The button works inside the car all the locks work. I did have leak through my ariel but fixed that while ago this is prob the problem but cant see anything obvious looks like im going to have to turn on my dodgey alarm

robi1000
06-04-2010, 14:41
I have the same problem. My car was satin the garage for half a year without acco and I think it lost synhronisation between ECU and key. There's a procedure how to synchronise it again(something witl lock button inside the car and unlocking with key within 10 seconds betwen pressing the lock button inside the car). I hope someone will remember the right procedure. If that doesn't help you have to go to the dealers to do it for you.

Wobba
06-04-2010, 14:53
The button works inside the car all the locks work. I did have leak through my ariel but fixed that while ago this is prob the problem but cant see anything obvious looks like im going to have to turn on my dodgey alarm

I had to cut the plug off a different car and splice it to the IR sensor as it had gotten so corroded the wires inside fell apart. Just prise the plastic lighting and board out (careful, electrocuted myself there once lol) and have a look.

Itsme
06-04-2010, 16:24
All looks fine in roof tried to put alarm on and that dont work now teach me for not using the car for so long!!!

Wobba
06-04-2010, 17:21
http://www.williamsclio.co.uk/forum/viewtopic.php?t=27103&highlight=key+fob

There ya go :)

Itsme
06-04-2010, 17:36
Tried that it dont work!
Was so hoping that would work aswell ive given up for today gona have to climb in and out of the boot now lol
Im going to have to get a new alarm for it or something will cost me same if I take it to renault to fix key

LEIGH-ANNE
06-04-2010, 17:45
What u gona do? U have taken out the reciever havnt u?

Could u not get a new reciever and new locks or sumthing will that be cheaper?

I dont use my locks at all....as ive got that alarm

Wobba
07-04-2010, 13:41
Could try resetting the ECU by disconnecting the battery for a while.
So it locks but wont unlock? So one of the plips works?

Coops
07-04-2010, 13:47
was about to say, disconnect battery completely and leave overnight, try again

if that doesnt work disconnect ECU as well :D

LEIGH-ANNE
07-04-2010, 14:08
I think the battery has been disconnected for a period of time over the months its been off the road anyway.


Hes changed batteries in the key fob bit. They work fine. Either the reciever or something else.

Worst bit is, hes got a cobra alarm.....the same alarm which totally disarmed my car for a good week or so....ended up ripping it all out and havign to spend £300 on a new one :roll:

Could the alarm somehow stop the central locking process in some way?

Coops
07-04-2010, 14:20
wouldnt of thought so, i have a cobra and the standard renault plip works totally seperately, i can lock up with the cobra and then use the plip to lock/unlock the car with no effect to the cobra and vice versa!

LEIGH-ANNE
07-04-2010, 14:35
So it HAS to be somthing with the plip or the reciever then. As hes had the alarm turned off for ages as it goes off when it feels like it :roll:

I reckon its the reciever...

So am i right in thinking that to change the reciever and to have it recoded...its near on £90 from reno?

Coops
07-04-2010, 15:02
something like that

with it being a williams tho any set of plip and reciever from scrappers etc will work, even if its off an RT etc, any phase, and model, provided its a working set of plip and reciever.

Coops
07-04-2010, 15:03
oh if yours works miss loser, be a good girl and swap it into his car to test ;-)

LEIGH-ANNE
07-04-2010, 15:28
It works now 8)


But im a reciever and a key down :roll:

Already thought of that Mr loser :wink:

Itsme
07-04-2010, 15:48
Well atleast it locks now ill keep that key Leighanne till you sort yourself out and go and pick up the boot I been waiting for!!!

LEIGH-ANNE
07-04-2010, 15:57
:yap:

fo

Wobba
07-04-2010, 16:35
Ahh good stuff. Ideally you wanna get down a scrappy, rip out the IR receiver and try to program it off you original key.

Coops
07-04-2010, 16:52
easier to just swap key internals :wink:

Wobba
07-04-2010, 16:53
easier to just swap key internals :wink:

Oh yea :oops:

Coops
07-04-2010, 16:57
although would you believe it that theres a difference between phase 1 and phase 1.5/2 keys :roll: :lol:

_PAUL_
07-04-2010, 17:18
Well atleast it locks now ill keep that key Leighanne till you sort yourself out and go and pick up the boot I been waiting for!!!

Yea LA come pick the boot up its in the bloody way :P
Only joking :wink: