View Full Version : My clio 16V
just a few pictures with my valver after a good clean.
katbloke
19-03-2010, 13:49
Shame the ngine bay looks so rough, doesnt match the exterior at all, if you were a sandwich toaster that would be an awesome number plate
yes i know. in spring i'll begin the work on the engine, and i hope it will match the exterior. the engine will have williams pistons with 1.9 diesel crank.
i'd get your steering wheel looked at mate, appears to be on the wrong side of the car :wink:
yeah ! you're damn right ! :D
manel16v
19-03-2010, 15:34
Hi,
What rims do you have?? I would put the original pieces of the valver! :wink:
wonderful fani from any angle........................ops forgot the comma
Hi,
What rims do you have?? I would put the original pieces of the valver! :wink:
the rims are speedline, 15' x 7J.
manel16v
20-03-2010, 10:50
Hi,
What rims do you have?? I would put the original pieces of the valver! :wink:
the rims are speedline, 15' x 7J.
but, the rims aren't the speedline gr.a, no?
cheers
yes, those are the exact rims.
i dismantled my engine - now it has williams pistons, another crankshaft, etc. and i can't remember where these part was from, and what is the position of the part. thanks in advance for the help.
zmaster2k
15-07-2010, 09:05
inlet to mapsensor?
thats a knock sensor by the looks .either screws into the head or
block right under it .
the metal pipe bolts on to the head on dizzy side ,its for the breather system.
izzz niiceeee http://www.renault9-11club.nl/phpBB2/images/smiles/icon_thumbs.gif
a picture that's worth a 100 words.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.