PDA

View Full Version : Nightmare Heater Matrix Change



DaneC
23-12-2009, 12:40
Had a terrible time changing heater matrix today - not with the matrix itself but putting everything back together!

Dash is back on but I have the following problems:

No power to the Clock
No indicators or Hazard Switch
Left Sidelight out
Left Rear light out (brakes are fine)
No sidelight light on the dials
A VERY wrong oil pressure reading.
Bad noise from the wiper relay behind the nearside tweeter.
No intermittent wipers
No electric windows
Engine runs fine though!

Any chance all of these run through one connector I may have knocked when I put the dash back on? I was quite violent pulling the dash off

Also I think I have f****ed the speedo cable, gonna have to change that f**ker later.

And finally, lost the drain screw on the radiator - and Renault can't get one in before christmas!! Annoyed.

DaneC
23-12-2009, 20:43
It was these that were unplugged, I cable tied my alarm wires to them when I fitted my alarm, and when I pulled my dash off they had nowhere to go so they pulled out.

http://i697.photobucket.com/albums/vv338/daneCbucket/23122009732-1.jpg

Speedo cable is fine in the end and I found the bleed screw so all is well!

MatBrown
23-12-2009, 21:04
See, all that panicking for nothing.


Mat.

kenny
23-12-2009, 21:38
Well done fella, back on the road for xmas, have a good one.