cliokongen
28-09-2009, 22:49
Finally started my ITB project.
Stripped the engine for std. manifold.
Unfortunately the ITB manifold does not clear the power steering pump.
It's a Williams head with the awful chadil manifold for Jenveys.
Has anyone experienced this before?
How did you solve it?
(remove material - how much?)
(Other solutions)
I know I could/should remove the PAS system.
That might be an option if a quick rack solution is found.
http://i50.photobucket.com/albums/f312/Cliokongen/Motorprojekt/IMAGE_405_edit.jpg
http://i50.photobucket.com/albums/f312/Cliokongen/Motorprojekt/IMAGE_406_edit.jpg
Stripped the engine for std. manifold.
Unfortunately the ITB manifold does not clear the power steering pump.
It's a Williams head with the awful chadil manifold for Jenveys.
Has anyone experienced this before?
How did you solve it?
(remove material - how much?)
(Other solutions)
I know I could/should remove the PAS system.
That might be an option if a quick rack solution is found.
http://i50.photobucket.com/albums/f312/Cliokongen/Motorprojekt/IMAGE_405_edit.jpg
http://i50.photobucket.com/albums/f312/Cliokongen/Motorprojekt/IMAGE_406_edit.jpg