View Full Version : Parts list for full ITB set up - Williams engine
What is the total list of parts needed for a full ITB set up:-
Including which flywheel and clutch and short rad etc.
Laine_16v
22-08-2009, 09:06
From the top of my head....
Manifold
Throttle Bodies
Throttle linkage kit
Air horns
Airbox backplate
Air filter
3m of Fuel hosing
Fuel Rail
Fuel pressure regulator
4 x Hi Impedance injecotrs
4 x Injector blanking plugs
Throttle position sensor
Optional Air temp sensor
Meganne Flywheel & Clutch
Low Profile Rad & Fan
AFtermarket management with distributer'less setup
Lots of nuts and bolts to put it all together.
Im sure thats most of it but no doubt forgotten someting.
Do you get new sensors too ? TPS / Coolant temp etc..?
AndyFielder
22-08-2009, 14:40
new TPS but the rest just use what is on the engine
sideways danny
24-08-2009, 00:38
dont need a rail or any hose. Use injectors in stock position.
Whatever ECU you get you'll need a megane/172 flywheel and clutch. New ECU should come with, or have available a TPS, air temp sensor and coolant temp sensor.
sideways danny
24-08-2009, 00:39
on and you dont need a regulator either, as if you use the stock rail in stock position, you can keep the stock regulator
sideways danny
24-08-2009, 00:41
Injectors!!!! you'll need high impedance ones most of the time with aftermarket management, so megane injectors are an easy solution
Injectors!!!! you'll need high impedance ones most of the time with aftermarket management, so megane injectors are an easy solution
your not @GDI :wink: :lol:
sideways danny
24-08-2009, 11:51
I know. Been trying to get hold of one of the admin for about 6 weeks now
:lol: par for the course
NNNOOOOOORRRRRRTHHHRRRROOOOOOOPPPPPPP, where are you boyo
sideways danny
24-08-2009, 13:23
it's Jon!! doesn't answer his phone, MSN or facebook messages at the moment :(
Dropped off the face of the earth.
You'll always be Dan@gdi in my heart :D
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.