PDA

View Full Version : LEDA Coilovers & Grp N 23.3mm Rear Torsion Bar



arj256
16-07-2009, 22:47
LEDA Coilovers & Grp N 23.3mm Rear Torsion Bar.
The closest you are going to get to Group N specification suspension.
For Clio Williams fitment. But with the camber adjustment, can't see why they wouldn't fit 16v models as well.
The coilovers are 6 months old from being unused. And have covered under 3k so as new.
What im selling:

2x Front Leda Coilovers with 2.5" 250lbs Eibach springs.
Rebound and damping adjustment together.
In built camber adjustment.
Comes with top mounts and bearings etc.

2x Rear Leda Dampers
Rebound and damping adjustment together.

2x Grp N 23.3mm Torsion bars.
No longer available to purchase from Renaultsport.
Very rare item!
Matches the rear spring rate with the uprated front.

http://i2.photobucket.com/albums/y29/arj256/Williams%20Parts%20For%20Sale/LEDACoiloversGroupNTorsionBar.jpg
Will clean them up when i have chance.

Considering that these coilovers cost £1200 new. And the Grp N torsion bars cost over £250

Im asking for £700

schakal
16-07-2009, 22:53
whats the length of the bars ??
i am assuming the ends are still as large as the standard ones ??

Justin..
16-07-2009, 22:56
he wont sell the bars seperate i already tried :(

schakal
16-07-2009, 23:00
he wont sell the bars seperate i already tried :(

when/where exactly did i ask him to sell the bars seperately ?? :roll:


:gay: :gay:

Justin..
16-07-2009, 23:01
:roll:

arj256
16-07-2009, 23:01
whats the length of the bars ??
i am assuming the ends are still as large as the standard ones ??

Im not sure off the top of my head.
They are identical length to the oem bars that came out of my Williams when i removed them.
Yes the ends are the same as the standard ones.
If you look at the torsion bars, they flare down from the flanges. So there is quite abit of room to increase the bar diameter over oem.

schakal
16-07-2009, 23:12
whats the length of the bars ??
i am assuming the ends are still as large as the standard ones ??

Im not sure off the top of my head.
They are identical length to the oem bars that came out of my Williams when i removed them.
Yes the ends are the same as the standard ones.
If you look at the torsion bars, they flare down from the flanges. So there is quite abit of room to increase the bar diameter over oem.

thanks mate
just to double check that 23.3 mm measured without
the rubber sleeve yeah ?

schakal
16-07-2009, 23:13
i am looking for 65cm long by the way .

arj256
16-07-2009, 23:19
Yes was measured without sleeve.

cliorod
17-07-2009, 00:28
Without hi-jacking this thread too much, :oops: :oops: .
I got a quote for a torsion bar ~~ I was guessing at the sizes.
I was quoted for a 1000mm long shaft with a 26mm diameter spline either end waisted in the middle for £170 plus vat each ~~ cheaper if there was a few ordered.
If I was to proceed,I have several Gp"A" shafts to get the exact sizes etc etc. to copy from :wink:
Rod.

arj256
19-07-2009, 23:33
Sold.