View Full Version : The time is near...
:D
http://img177.imageshack.us/img177/8879/pic0km.jpg
KingStromba
05-07-2005, 22:34
What wishbones are they?
Should be good, looking forward to the track day to test them fully. 8)
KingStromba
05-07-2005, 22:43
Williams track?
yes... all new bits from reno as you can see!
KingStromba
05-07-2005, 22:45
Good man.
will u be doing this with the car on axle stands? if so just make sure u got enough room to get the ARB in as it was tight on bayliss's old en to fit it on, other then that have fun!!
just need to slam it a bit now...
http://img177.imageshack.us/img177/170/willytrack23la.jpg
i can now they was white box with red x lol
get it lowered now takes 5 mins :wink:
Marin I'm not sure what poundage spring etc your using but I found the car cracked the arches when I backed of the dampers on the track hence I've had to go back to the setting you had.
When I get a chance I'm going to get some spare arches spray them up and cut a huge bit out of them and lower the car further. I'm sure with stiffer springs (£50) theres another 3cm or so lowering in there. My Spax setup only had 5cm or so free on the damper with no probelm the gaz coilovers have about 8cm still.
Will take it down a bit tommorow if I have time...don't want it too low tbh I have some bumpy roads round my way.
very nice mate..
are you fitting them yourself ?
eh they are already on northy see the pic lol But no did'nt do it myself..
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.