View Full Version : plug on valver loom?
lewis_willy2
04-07-2005, 12:12
ok i gt my engine in and its nearly ready to go but there is 1 plug which has no label! its easy enough to find, it runs along the TB, i think its between injector plugs 2 and 3, anyway its a GREY wire(possibly if a can rememba a brown plug) but i cant find where it goes other than a BLUE socket under the TB, not sure if its the same on a valver but i imagine it is, if anyone cud take five minutes to av a look wud be great as i wana plumb my baby up 2nite and get it running for santa pod?
is there any plugs on the loom that arent connected atall? is so which ones?
Sounds like the 5th injector plug
lewis_willy2
04-07-2005, 12:34
wheres that situated?
lewis_willy2
04-07-2005, 13:08
is it blue or am i lookin wiv my eyes closed?
Yes its blue ....and has a metal pipe from it going to the fuel rail
lewis_willy2
04-07-2005, 13:21
i thought that was the one, didnt reach tho, will re route it! thanx winston.
N/P ....Think you have to feed it through the gaps in the inlet manifold
Nick Hill
04-07-2005, 19:32
If the wire is grey and the connector block is a 2 pin brown connector then its for the Knock sensor which sits just below the cylinder head between 2 and 3 cylinders. The cold start wiring has a black connector block and breaks nout from the wiring harness just before the wiring to the rad fan.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.