View Full Version : problem with k-tec 285mm big breaks
paudi294
03-01-2009, 16:00
has any one had these the 4pot ones and had any problems with them as my disc wint fit over the hubs
cheers
Matt_16v
03-01-2009, 17:38
I have the NON 4 pot brake kit.. The one which uses std calipers, that is 285 and went over the hubs fine. I would assume that they would use the same discs?
Matt
I would say you have the wrong discs as I had that big brake kit and it went on fine and dandy.
paudi294
03-01-2009, 17:48
ok cheers lads i sure i ordered the right ones they must have cocked up wouldnt b the 1st time they have lol, ill have to get hold of them
cheers
They sent me the wrong discs first time - the holes to the hub didnt match up but they were 99% correct. Seems odd they sent you discs which were that far wrong.... Your not doing somehting silly are you?
paudi294
03-01-2009, 19:01
no m8 def i messured the hole in the middle up againts the org disc and ther 3mm smaller then the org 1s and the bolt holes r slightly out. and tryed other hubs still no good.
Mark One
06-01-2009, 14:13
the discs are meant to be off a Renault 21 2.0 non-turbo. 285mm, chassis L48Y I think
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.