View Full Version : Williams Gearbox JC5
50..... ono
Because one of the tripod bearings has come off the passenger drive shaft and is lost into the box along with the pins... The gearbox has not been run since the bearing came off, my own fault for leaving the driveshaft on
The box has covered 85k and was a sweet box, It could be pulled apart and the bearing & pins removed or used to send for a rebuild
Pick up from N/W.. I can travel within reason to meet
Cheers
PS also got a passneger williams shaft that needs a new tripod ( you can fit your valver tripod) - £10
Winston,
I am interested in both :wink: :wink: ,txt me or ring sometime Sunday
Rod on 07952377880,can collect halfway Monday ~~~"Winfields" on A/M66 ~~ cash :lol:
If Rod doesn't have it i'll have 2nd dibs
07977 236763
Winston,
I am interested in both :wink: :wink: ,txt me or ring sometime Sunday
Rod on 07952377880,can collect halfway Monday ~~~"Winfields" on A/M66 ~~ cash :lol:
What do you want it for Rod ??
Need one of these myself to get my new diff and lowered final drive into..!!!
It seems someone got to Winston before he read my reply or my pm.
:cry: :cry: :cry:
Gutted as I need one rebuilding for my road car
Evogone,
Need one of these myself to get my new diff and lowered final drive into..!!!.
Make sure your diff has the correct type of bearings :wink: :wink: I am not sure which way round it is,but one is a taper bearing and the other is a parallel one.
I found this out the hard way,mine now rests in a JB5 ~~ no probs.
MatBrown
05-01-2009, 20:20
It seems someone got to Winston before he read my reply or my pm.
:cry: :cry: :cry:
Gutted as I need one rebuilding for my road car
I have one available that needs a rebuild.
Mat.
Evogone,
Need one of these myself to get my new diff and lowered final drive into..!!!.
Make sure your diff has the correct type of bearings :wink: :wink: I am not sure which way round it is,but one is a taper bearing and the other is a parallel one.
I found this out the hard way,mine now rests in a JB5 ~~ no probs.
JB3 (16v)- parallel
JC5 (Williams) - Taper
Think its that way round, anyways my bits will be for the better JC5 Willy box.
:lol: your fixated by the JC5 being "better".
you shouldnt have sold that sadev dog-box you bought. you should have at least fitted it and used it once!! :lol:
Must admit,I have to agree with Stan ~~ There are not any better boxes around than a SADEV box :roll: :wink:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.