View Full Version : williams and clio 16v arb diameters ?
can someone that actually measured them tell me
what they are please?
Dialooooooogys says 22 & 23mm respectively
yup as above, on the 17 2/18 2 they changed it to 25mm
25mm :o
they look like they'll fit too :D
only issue there might be is the arb design is slightly different between the 2 centre mounting points, as on them the exhaust goes over the subframe, not under like ours, ive compared them on my 18 2 and hybrid and it may fit, just not prepared to take it off the 18 2 lol
i have a 1*2 exhaust setup anyway :)
i have a 1*2 exhaust setup anyway :)
your laughing then!!
Dialooooooogys says 22 & 23mm respectively
i remember seeing 21 and 23 for 16v and williams when i looked at
dialogies a while back .
am i right thinking thicker bar = less flex hence better
handling ?? or is there a limit to how thick you can go ?
:P
yeah thicker is stiffer mate, look at the arb on a 26 ton lorry, its like 100mm :twisted:
Justin..
06-12-2008, 17:51
mk2 artb wont fit , the arb loop will hit the shell
im sure someone tried it on clio16valver
Justin..
06-12-2008, 17:55
mk2 artb wont fit , the arb loop will hit the shell
im sure someone tried it on clio16valver
Dialooooooogys says 22 & 23mm respectively
i remember seeing 21 and 23 for 16v and williams when i looked at
dialogies a while back .
am i right thinking thicker bar = less flex hence better
handling ?? or is there a limit to how thick you can go ?
:P
those were the numbers Stromba chucked around recently... but he was probably just making things up.... again. Dialogys says 22mm and 23mm for the ARB for 16v and Williams; backed up with the notes included for the inner bushes. I've got a valver ARB and a Williams, but never bothered to measure them (don't have verniers anyway) and my Williams one has a layer of hammerite on it :D
with the Williams being 23mm and the valver being 22mm, the Williams would be approx 20% more rigid.
if the valver were 21mm, the difference would be about 43%.
Justin, can you remember who it was that tried that mk2 ARB? did it definitely hit the shell.. or was it the exhaust?
Justin..
07-12-2008, 01:48
this is what i could find, the picture is gone though
http://www.clio16valver.co.uk/forum/viewtopic.php?t=19043&highlight=172+widetrack
Justin..
07-12-2008, 01:49
where the hump on the mk2 arb is there is no chance it will fit a mk1
just curious as he didn't actually test it did he?
i will jack up the 18 2 later and get some pics/measure height as im fairly sure it was only the exhaust position that would be a issue!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.