View Full Version : Picture request standard williams pistons and cams
franksvalver
03-11-2008, 00:41
As above
Took my head off today and are a different look to the standard valver pistons
franksvalver
03-11-2008, 00:58
http://i265.photobucket.com/albums/ii220/frankybabyy/L%20reg/DSC00967.jpg
http://i265.photobucket.com/albums/ii220/frankybabyy/L%20reg/DSC00964.jpg
Is this all standard?
Only reason i ask is because the engine had a piper cams cambelt and a very new head gasket on. Everything just seems so very clean on the engine. The inlet ports are extremally clean and theres no oil staining on the head
franksvalver
03-11-2008, 01:01
http://i265.photobucket.com/albums/ii220/frankybabyy/L%20reg/DSC00967.jpg
http://i265.photobucket.com/albums/ii220/frankybabyy/L%20reg/DSC00964.jpg
Is this all standard?
Only reason i ask is because the engine had a piper cams cambelt and a very new head gasket on. Everything just seems so very clean on the engine. The inlet ports are extremally clean and theres no oil staining on the head
The pistons are standard. Not sure on those cams as i dont have a williams head
drsmith1979
03-11-2008, 03:12
Stans you man for this....
don't cams have their id code stamped into the end though?
think valver cams had 234 written on them, but defo 2ltr pistons
thing is even the standard cams get re ground so without checking the ends etc..measuring lift...its a little impossible to tell..
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.