View Full Version : Non interference engine??
I know this is the williams site but there seem to be a lot of 1.8 16v users on here so could anyone tell me if the 1.8 16v engine is a non interference engine!?
Cheers
Stu
PS my father in law just bought that mint 29,000 mile williams 3 a few of you may have seen advertised.
I've just bought a valver as a track slag!
as it what way mate...
i interfere with mine all the time...
if you mean the engine settings and map then yes but the ecu can be re mapped by a few specialist's to allow cams headwork etc to be included in the system.. 8)
or you can go standalone if you want to upgrade further..
No sorry mate, should have been more specific. If the cambelt snaps will the valves hit the pistons. Thats either interfere or non interference!
Cheers
Valvers ae interference
I know from past mistakes, lol
Ah right, cheers! I think!!
yes they always tend to be valves....
but are very cheap to source secondhand... 8)
LEIGH-ANNE
13-10-2008, 21:24
as it what way mate...
i interfere with mine all the time...
if you mean the engine settings and map then yes but the ecu can be re mapped by a few specialist's to allow cams headwork etc to be included in the system.. 8)
or you can go standalone if you want to upgrade further..
Can u come and interfere with mine......needs sorting :D
her water works are dodgy !
Justin..
13-10-2008, 22:16
lol here we go again
LEIGH-ANNE
13-10-2008, 22:33
Good call was trying to think of sumthing that needed sorting :wink:
Justin..
13-10-2008, 22:33
:shock:
another thread she enters drops into filth
:lol:
LEIGH-ANNE
18-10-2008, 23:38
my water works are really dodgy!
My water pump is still ****ed! :(
Leighanne has a bad leak, it's always wet if you check under her skirting.
did the radweld fail then ?
After the awesome same peice of advice 5 times in 2 minutes at pod lol
Leighanne has a bad leak, it's always wet if you check under her skirting.
LOL
Justin..
19-10-2008, 11:42
did the radweld fail then ?
After the awesome same peice of advice 5 times in 2 minutes at pod lol
yeah yeserday it was leaking. worse tho :(
put some more woter and rad weld in and it got her home from town ok.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.