View Full Version : cup racer suspension geometry
anyone know the geo figures of a cup race car? obviously different teams/drivers would have there car setup differently
basically want to know what they ran so i can set it somewhere near, ie toe in/out, front camber, any rear camber using shims?
any help appreciated :D
Tracking is set at 0degrees (as a road car)
Camber is fixed at -4degrees both sides (standard)
No rear camber but lowered to suit the track.
Camber was adjusted to suit the circuit but mine is 100% 0 degrees
white16valver
04-08-2008, 16:13
4 degrees negative camber!! :shock:
Inner edge wear anyone? lol
I thought road tracking was 5 to 15 minutes toe in on standard road cars though? :?:
usually 0-2 toe in on front wheel drive cars iirc... Camber angle is badass! might have to invest in camber correctors ;)
Thought cup racers where 3 degrees, as thats what it sat in the paperwork i have..... :?
Thought cup racers where 3 degrees, as thats what it sat in the paperwork i have..... :?
what does it say about the rest of the geometry?
Not a lot to be honest...
It does say that caster is adjustable by modifying the wishbone bushes...
You will need a genuine Renault wishbone/bushes to do this on however as the aftermarket/gsf ones do not permit for caster adjustment.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.