Metal pipe

[KingStromba]

Runs across the engine into the inlet manifold area. What is it?

[Winston]

lol ...That really did tickle me

Vacuum pipes?

[Swervin_Mervin]

Whereabouts exactly? Could be the fuel rail at a guess. That runs between the inlet fanny mould and the rocker cover.

[KingStromba]

LOL, whats funny Winston? Am i being a spastic? :D

[Winston]

Just abit vague lol

[KingStromba]

Ill get a picture after my tea :D

[Mark_Ritchspeed]

I'm guessing your refering to the pipe that feeds the brake servo. Runs around the front and side of the engine and one end goes into the inlet fannimold and the other is connected to a rubber pipe sleeved with heat resistant material that then goes into the servo.

If its not that, I've just wasted a lot of time and energy typing all this crap. :roll:

[KingStromba]

Yeah i think your description is spot on. Anyay its rusting. What do i do?

[Mark_Ritchspeed]

Nothing.

Although I suppose you could take it off (easy enough) and rub it down and repaint it with satin black aerosol. Its very, very unlikely to actually rust enough to corrode right through though.

[WeZ01y]

Thats the pipe i had to cut thru and replace with some silicone hosing to fit an ecotek valve.... my advice, dont be a sucker like i was :P

[KingStromba]

I'm guessing your refering to the pipe that feeds the brake servo. Runs around the front and side of the engine and one end goes into the inlet fannimold and the other is connected to a rubber pipe sleeved with heat resistant material that then goes into the servo.

If its not that, I've just wasted a lot of time and energy typing all this crap. :roll:


After all that you dont actually say what it is? :D

[Lunner]

The pipe that feeds the brake servo :roll:

[u33db]

They're cheap enough from renault brand new - i bought one a while back as i cut the original one...think it was about 25quid bit don't quote me.