View Full Version : Williams box on a Valver ?
firstly will it fit, which i think it probably will
but, how will it drive due to the ratios being different
lewis_willy2
03-03-2008, 14:38
in experience it depends on the phase of engine to box. i bought a box for my m8s phase 2 valver and the top lines up but the bottom of bell housing and locating lugs didnt fit.
i assume its the same with williams to valver.
correct me if im wrong someone
thanks mate, 1 even possible problem is too many lol, ill just look for a valver box
lewis_willy2
03-03-2008, 14:41
it would prob be cheaper to get a valver box imo
BRUN, just get a 1.2/1.4 JB1 box.
It'll be fine for the amount of power your car has and is the cheapest option.
isn't the willy box same fit but closer ratio?
Same fit, different 5th and apparently stronger.
Willy box is definatley the same fit, the reason some of the bellhousings dont match is because of the diesels, smaller petrols and i think even rsi's having steel sumps and theres a plate that goes between the box and sump on these, they all fit though
number1 is right, the difference is the bellhousings on the steel sump engines
eternalife
06-03-2008, 11:48
http://i145.photobucket.com/albums/r229/valverflavour/exposed_flyw_306.jpg
so basicly, a new sump will do ? :D
Nope just leave it with the gap there, dont think you can change a valver alloy sump for a steel one without changing the pump etc and loosing the baffle
BristolSam16v
09-03-2008, 22:40
As above, that pic is what mine looks like as well, just bolted up as many as I could, its been running fine since feb 07.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.