Valver Problem

[16V-AL]

recently changed the engine in my car and it now wont idle unless you hold the car around 2000rpmnow i did strip down the throttle body and all fittings around it and cleaned them when i changed my engine but dont think this would have affected it. runs fine when on road but wont idle at all? any ideas people
cheers in advance

[davem]

check all the pipes and check idle valve is plugged in.
did you remove tps when cleaning throttle?
if so it will require resetting.

[Lunner]

do a search someone had this problem, stripped it all down and ****ed the settings up, going back a while now....might have been brun, but not sure

[Lunner]

Thats the one i think

http://www.williamsclio.co.uk/forum/viewtopic.php?t=9154&highlight=tps

[16V-AL]

The tps is the red sensor on the side of the throttle body isn't it?? If so i hav removed that. How can i reset this or is it just best to replace?

[Coops]

start car and wiggle the bugger till it idles right, theres proper settings for resistane to set it up but i have never got them all right so the wiggle it techniqye comes into play :wink:

[BRUN]

ive posted the settings for it, however it needs testing at the ecu terminals so not very simple to do

[16V-AL]

Problem solved!!!! wiggle technique done the job. cheers :D

[Coops]

:wink: