High Temp Loom Tape?

[MattyH16valver]

I started to remove the bit of the loom thats connects to the starter motor and this is right near the manifold....theres also a piece of rubber piping over the top of this too.....once i've removed my old melted battery cable and come round to replacing it can anyone suggest a decent high temp tape to use near this manifold area? Cheers...Matt

[Lunner]

Look in tweeks or rally design catalogue, they do a variety of heat protection for wiring, not cheap tho

[MattyH16valver]

Look in tweeks or rally design catalogue, they do a variety of heat protection for wiring, not cheap tho

Cheers mate :D

[schakal]

Look in tweeks or rally design catalogue, they do a variety of heat protection for wiring, not cheap tho

demon twats will bum rape you for a piece of pikey tape mate
look on ebay for heat wrap tape , i got a roll from there
to use on fuel lines to save them from the zorst pipes .

[Lunner]

Personally i prefer just wrapping the manifold :D

[schakal]

Personally i prefer just wrapping the manifold :D

lol ,my manifold is no where near the fuel pipes dude :wink:

[MattyH16valver]

Look in tweeks or rally design catalogue, they do a variety of heat protection for wiring, not cheap tho

demon twats will bum rape you for a piece of pikey tape mate
look on ebay for heat wrap tape , i got a roll from there
to use on fuel lines to save them from the zorst pipes .

Cheers

[Lunner]

Personally i prefer just wrapping the manifold :D

lol ,my manifold is no where near the fuel pipes dude :wink:

Nor mine....but it is as std ;)

[schakal]

Personally i prefer just wrapping the manifold :D

lol ,my manifold is no where near the fuel pipes dude :wink:

Nor mine....but it is as std ;)

what i meant is ,i am running a custom zorst setup which
happens to go parallel and quite close to my fuel lines
on the R9 ,being over cautious i gave the fuel lines a wrap
of that heat tape ,worked out cheaper than wrapping the exhaust lines .