PDA

View Full Version : 1.8 Port & Polished Cylinder Head (By Nick Hill)



Laine_16v
19-12-2007, 21:04
Pics will be up tommorow,

The engine was built by nick hill (that i am splitting), this head has been port and polished with new steam seals e.t.c, the head has covered roughly 50k miles since it was done and performs similar to that of a standard F7R head but has the benefit of bringing the torque in from lower down due to smaller valves with very little difference to peak power.

Comes with cam cover, thermostat housing and a few other bits and standard williams cams (if i can find them), but will confirmed tommorow.

Dont really know its value but its gota be £100 or so.

Laine_16v
20-12-2007, 18:41
OK the head is in my possesion now, sadly the blow between cylinders has casued a slight ridge (you can feel it if you run your fingernail over it), so will require a skim (£30-£40).

The inlet / exhaust have clearly been worked on, here are some poor quality photos :P

http://i133.photobucket.com/albums/q51/laine_16v/Image020.jpg

http://i133.photobucket.com/albums/q51/laine_16v/Image021.jpg

http://i133.photobucket.com/albums/q51/laine_16v/Image024.jpg

http://i133.photobucket.com/albums/q51/laine_16v/Image027.jpg

MatBrown
21-12-2007, 13:30
How many times has it been skimmed so far?


Mat.

Justin..
21-12-2007, 13:35
would you sell willy cams seperate?

schakal
21-12-2007, 13:42
How many times has it been skimmed so far?


Mat.

you thinking what i am thinking ?? :roll:

Laine_16v
21-12-2007, 13:46
How many times has it been skimmed so far?


Mat.

Once in my ownership.