PDA

View Full Version : Itb throtte Bodies on Meagne f7r manifold


Sam16v
09-10-2007, 21:12
Right bought these tbs and manifold to fit to my megane engine that was going into my clio. but have sold up and only have these and a few other bits left. The manifold alone was purchased from stan at A.P.Developments for £260 (special order from belgium) and has never been used on a running engine. The throttle bodies are brand new Lotus esprit turbo items that have been coverted to fit the manifold. these throttle bodies and maifold are very compact and you will be able to fit at least three inch trumpets. there is no TPS on the bodies but weber do a TPS kit for there carbs which should be easy to fit onto these (What i was goign to use). Bargain price because im so skint £300 has cost me way over double this! feel free to ask any questions cheers Sam
http://i2.photobucket.com/albums/y33/samprankerd/S5030468.jpg
can get some more pics if required
Mr.AdamB
09-10-2007, 22:47
pmd ya mate
drsmith1979
09-10-2007, 23:27
pm'd
Dan_mk1
12-10-2007, 15:14
Sam pm your mobile number fella, ill definately have these as per pm.
Sam16v
18-10-2007, 20:38
Provisionally sold to Dan mk 1
matty w
18-10-2007, 22:15
Provisionally sold to Dan mk 1

have you sorted the megane manifold out mate?
AndyFielder
02-05-2008, 09:44
the manifold still around?
evouk
02-05-2008, 15:31
can cofirm i have had to order a manifold from CHADIL in belgium costing "284 in total!!!!

Expensive but only place that makes them
Dan_mk1
02-05-2008, 15:41
I have it, why?
AndyFielder
02-05-2008, 15:54
was looking to buy one... jenvey do a megane manifold off the shelf!
evouk
02-05-2008, 16:14
yes jenvey do one for the megane but not for the twin dcoe style attatchments....
AndyFielder
02-05-2008, 16:56
theres only for individual bodies then.
evouk
02-05-2008, 16:59
yes yes :)
MicKPM
02-05-2008, 18:19
yes jenvey do one for the megane but not for the twin dcoe style attatchments....

It also needs some minor modifications to fit which I vented to Richard about... Bottom bolt holes are that tight to the outter cast that you have to trim the K-Nuts' outer sleeve off to fit them. The ID of the port is slightly smaller than the ID of the Jenvey 48 tapered bodies so needs material removing and finally, after all that it's not cheap either (I know as I bought my setup from them)

Mick