View Full Version : slow willy
my willy 2 seems far too slow to me and top end is ridiculous at 112mph. could this be because the clutch is on the way out? havnt got any noticable slipage and the engine revs all the way to the redline in 5th! is there any quick tests i can do such as tryin to pull away in 5th and seeing if the car stalls?
where abouts are you.
can you find a gearbox code
bristol, yeh looked the other day says j5
check air feed to airbox, if its blocked/kinked it will restrict the engine
jc5. maybe its the clutch. its difficult to say without seeing it.
have an ask theres a few boys around bristol might have a look
checked that was in wrong place have moved it but hasnt made a difference
yeh jc5 sorry mate, the clutch is on about 50, 000 now anyway so i mite just change it and see if there is any difference
just took it for a drive it stalls in third if u try and pull away so doesnt seem like the clutch is slipping, but the limiter doesnt cut in until onver 7500rpm could somebody have chipped it and mapped it incorrectly or be running a different ecu?
Easy way to test for clutch (assuming you have a good handbrake).
Park up, pull the handbrake on real tight.
Try to pull away in first giving it some revs (no more than you normally would). It should stall. Clutch is doing it's job. To many revs and obviously you'll just drag the rear wheels.
If you're hitting 7000 odd revs at 112 in 5th gear, sounds like you have some funky ratio's or final drive going on inside that box.
Assuming standard limiter of 6500 in 2nd gear you should be changing to 3rd just before 60 at around 55mph.
Bit odd though. If he has a a higher ratio box, he should accelerate much quicker, and as mentioned his top end will suffer. So his comment about it being slow is odd (points to other problems maybe?).
Sounds daft but if you try it down hill straight can you get a higher speed at the same revs?
Lastly, borrow a GPS unit and check your speedometer against its speed.
Matthew
lol (dont know why im laughing its not funny really) but that was downhill i was getting that speed. i took the ecu out and it has siemens s101715103 b on it, read somewhere on here that the serial number ending in 107 is williams ecu, ending in 105 is valver so assuming this could be an rsi ecu? renault arnt sure what ecu it is dont know why but they were rather vauge, it has a prima racing sticker on and they dont recognise it either
Justin..
30-08-2007, 19:38
wont be ecu effecting the speed. but if you only get 112 at limiter in 5th its deffo a gearbox ratio problem, does it get to 112 quickly or are you just sayin the top end is slow? should be able to get 145 easily
Justin..
30-08-2007, 19:40
might be a renault 19 16v ecu ?using a 16v ecu will just make it run lean anyway. open up the ecu box and see if the main chip has ben changed
iv got a valver ecu in there think thats what the problem is its chipped as well.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.