Inlet manifold.

[Bailey_1260]

Is there an easy way/knack to getting these off?!

Took one off a scrap engine today to have it cleaned and coated but what a bitch of a job to do, had to remove the mounting bracket and PAS pump and whip off the fuel rail (getting petrol everywhere)

Was going to swap them over once the new engine was in but now im not so sure its a viable "In car" job.......without being Beadle

[summeh]

yeah it can be done in car just quite fiddly... when u put it back on tho if u want to make life easier dont put the side bracket and lower (pas side) one on (airbox side u need to support the dipstick iirc).

been a while since i done mine but it's pretty much a rad out job, unless you can get enough access by dropping the rad forward.