Valver and williams looms??

[WILLIAMS2TURBO]

Is there any differance in the two?

Ive had a engine transplant done (bb williams2 turbo from a 1.8 shell to a williams2)

And since it hasnt run right :evil:

Its been in the garage a few weeks now and they carnt seem to find the problem!

They think the pins from the loom to the ecu could be differant as the temperature sensor is doing a thing etc?

Hope that helps any help,ideas would be great,

Is it possible to get diagrams of them? (cable pin thingys) lol

Paul.

[dan-hipgrave]

I thought the only difference in looms was with the fuel pump wiring but I may be wrong - I know that when I did my engine conversion (1.8 to Williams) I used the 1.8 loom with the new engine and had no problems at all.

[Amirclio]

I had a 1.8 to williams conversion, used the 1.8 wiring loom. Works fine :)

[cliokiz]

Using a williams loom on my williams engine in my valver shell

No probs 8)

[stan]

as per cliosport, depends on phase.

Try the MAP sensor wiring. The problem doesnt sound like a wiring loom issue.

[WILLIAMS2TURBO]

Cheers stan,

Only thinking the loom as ive been told that the part where the loom fits in the plastic case which then fits into the ecu could be differant???