power steering hose route

[matty w]

has anybody got a picture of where the power steering hose goes by the gearbox on a phase 1 valver

[Coops]

it goes under the edge of the box and is held in place by a clip on the inside edge of the subframe just about where the wishbone is attached, no pic tho am afraid!

[matty w]

cheers mate,so it goes under the driveshaft?

[Coops]

ai fairly sure it does

[MatBrown]

Yeah, they all go under the driveshaft.


Mat.

[cliokiz]

Mine doesn't! But i'm using a valver P/S pipe on a williams engine so it's a lot shorter, so mine goes over the top of the gearbox! Had to snap all the clips that held it in place :shock:

[Coops]

erm, aint valver and williams identical set up, as the engines are the same absolute dimensions! :?

[Rich]

richys williams is different. has more metal pipework than usual

[Coops]

oh ai, remember this being metioned at some point, my bad!