View Full Version : offset/bore
Ahmed Bayjoo
24-06-2007, 20:42
what is the offset and bore of the williams speedlines?
wat are the effects if you get alloys with a different offset?
Ahmed Bayjoo
24-06-2007, 21:14
would alloys that are 7 x 15 et 12 bore size 57mm fit on a williams
et of 2? erm i wouldn't do that matey.
36 is the standard for the williams
Ahmed Bayjoo
24-06-2007, 22:24
thanks chris
any idea of the bore size on a williams,
could u go to a slightly higher et , say 38 , or lower 34 would doing that have any detrimental effects
bore is 60.1mm offset effects where they sit in the arches. to high it will rub the strut etc to low et12 will sit out and hit the arch
Ahmed Bayjoo
25-06-2007, 00:12
nice one exactly what i wanted to know :) , was looking into split rims, they all seem to come in very low offsets
yeah lots of split rims are for rear wheel drive cars that usually have a lower et.
Clio_GTT
25-06-2007, 17:39
PCD 4 x 100
ET 36
Centre bore 60.1 mm
The offset is the distance from the centre of the wheel to the face that mates with the hub, on the clio it is a negative number, the smaller the number the further out they're pushed, you can get away with a bit on 16v track but not on the williams.
If you want deep dish wheels you could fit an RSi/R5 GTT rear beam and maybe RSi/RT front track
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.