PDA

View Full Version : Piston/Rod Direction



Coops
03-06-2007, 18:32
right, after checking the wossners, they have an arrow stamped on the crown that can face to the front or the back of the engine, so from standing in front of the car facing to the back, which way will the pistons go?

and also does it matter which way round the con rods go, as the writing on thier caps can face front or back of the engine in a similar fashion but from underneath! :lol:

any advice appreciated!

cheers

Coops

snowman
03-06-2007, 18:46
Always thought that arrows should point to fly/gearbox end of engine.better double check against somebody elses answer tho :?

Crossers
03-06-2007, 18:52
As above, they should point to the gearbox/fly wheel.

I'd post pics if i knew how :oops:

Paul

Coops
03-06-2007, 18:53
nope, can only point front or back, not possible for them to point left or right to gearbox or cambelt :lol: cheers anyway tho lads

Crossers
03-06-2007, 18:57
Can't help u there then, the o/e ones deffo point as stated.

Paul

MAXIBOY
03-06-2007, 19:19
i would point them back myself. :twisted:

Crossers
03-06-2007, 19:25
Seein as the pistons are new, i can't see that it'd matter?

It clearly would if you were to strip the engine again after the rebuild, perhaps thats why the markings are there, so you have some reference when stripping/rebuilding using the same parts?

Just a thought.

Paul

MAXIBOY
03-06-2007, 19:34
it does matter as they have an offset pin to minimise piston slap when cold.

Coops
03-06-2007, 22:53
lookin at pic from your rebuild thread mate it looks like arrow points to rear of block on your pistons which are wosseners n all aint they iirc?

this pic you can make out a feint arrow on the centre of the crown and its pointing away from oil return gallery which is at front of block isnt it? rekon i should go with the same then?

http://i14.photobucket.com/albums/a330/coopahstar/DSCF3172.jpg

MAXIBOY
03-06-2007, 22:56
yeah i phoned andy at bb when i did mine and he checked with germany and said they pointed to the rear of the block. pity really as i had fitted them the other way and had to change them round.

Coops
03-06-2007, 22:57
typical! :lol:

right i'll do it that way then, good news as i've fitted them all to the conrods so the writing on the end caps is the same way round as on the main bearing caps aswell as that seems to make sense to me as how it should be! 8)

MAXIBOY
03-06-2007, 23:00
yeah but i,ve no writing on my end caps :D

Coops
03-06-2007, 23:07
mmmmmmmm..........forged!

stan
04-06-2007, 10:12
yeah, arrow towards rear.

Coops
04-06-2007, 18:12
8)