View Full Version : Bearings mix up
right, when i whipped out my pistons i failed to note which rod and bearing assembly came of which crank journal and have since undoubtably mixed them up
my question is can i reuse the bearings and risk sticking them on the wrong journals or will it not matter?
cheers
Coops
for cost of normal bearings, I would just repolace them mate.
What pistons have you gone for in the end, Wossner?
yeah, neils sorted them for me.
are willy n valver bearings the same?guy on for sale sellin willy ones was gonna have them!
Yeah the same, just make sure they are the right size!
VIPERONE
31-05-2007, 07:33
check the sizing on the ones you removed.
what part of them do you measure?
thickness and ideally clearance
walk me through it my good man
thickness seems simple enough, but surely they will of worn? :?
clearance?no idea what that is tbh! :oops:
Sizing is usually stamped on the big end bearings, i know this as i made that mistake of not looking and replacing with standard and later finding it had had a .25mm regrind!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.