PDA

View Full Version : throttle bodies



setb
18-05-2007, 11:28
what kind of preformance will I get when I put throttle bodies on my williams phase1 with light tuned engine ?

MAXIBOY
18-05-2007, 11:30
up to around 220bhp 230bhp with head and cams and correct mapping

evouk
18-05-2007, 11:51
and about a 3k bill!!! :D

ballcrusher
19-05-2007, 16:06
with light head work 220/230 bhp dont be silly

MAXIBOY
19-05-2007, 18:30
with light head work 220/230 bhp dont be silly


read me answer. i said with head cams and mapping 220bhp 230bhp. no point putting expensive bodies on before head and cams in my opinion.

ballcrusher
20-05-2007, 01:35
well that aint what the guy asked about so with bodies ya looking about 200bhp-ish if its mapped wright

MAXIBOY
20-05-2007, 10:16
says with light tuned engine. in my opinion head and cams are a light tuned engine. suppose its open to interpretation

Fusionrs
20-05-2007, 10:40
Id consider mine as lightly tuned -

TBs
Catcams
APD head


......no silly big 300bhp turbos here :wink:

finlay
20-05-2007, 13:25
Id consider mine as lightly tuned -

TBs
Catcams
APD head


......no silly big 300bhp turbos here :wink:

what kind of power/performance is yours putting out ? cause thats the route i m taking in the near future, but i m putting in steel internals, should rev to around the 9000 mark with cams to suit

cheers Finlay

dimkais
20-05-2007, 15:42
If you want to rev above 9k then you will have to put in VERY wild cams (more than 300deg),but in order to do something like that you will have to make many changes to the head.Also, if you keep the std stroke you will never see the revs exceeding the 9400 as the stroke is not helping skyhigh revving at all.BUT....if you do these changes you will have more than 250hp :wink:

Fusionrs
20-05-2007, 16:00
Well my engines still on its stand next to the car at the moment as im just waiting for myt mate to get his DTI gauge from work to set up the pulleys.

Hoping for around the 200bhp mark to be honest