PDA

View Full Version : drive shaft and thermostat



NAPLES VALVER 123
05-05-2007, 11:37
some of you may have read in a previous post i was having trouble remving the rollpin :x . In the end i had to cut the gaiter and get it out that way :( . My question is the rollpin doesnt seem to be moving, is it possible that when i put the engine back in i can conect the drive shaft and put new gaiter on when in car?

also which way around does the thermostat go in to the engine block :oops:

MAXIBOY
05-05-2007, 20:38
yes but better to drill roll pin out if you can. thermostat with the spring inside the head.

NAPLES VALVER 123
10-05-2007, 17:03
right ive spent hours on this dam roll pin, gone through a number of drill bits etc.

Ive tried everything. would it be hard to just fit the engine and refit a new gaiter which ive cut to remove engine.

any help would be great thanks 8) :cry: