mikeymikewakey
27-04-2007, 07:35
Ive never actually looked inside an engine before but im gonna learn as i go and i was wondering if the cylinders would have to be ground out to make the extra capacity or wether or not there a liners inside the cylinders that i coulc replace with thinner ones?
I assume i would need to replace the pistons with meggy or williams ones and if i did it would i also require a new crank or would a 1.8 and 2.0 rank be the same?
Alot of you may think, just get a 2.0 engine - but this valver engine i have has only covered 30,000 miles and its mint, very tight and quick, quicker than my last valver, so i wanna keep this engine where possible.
Cheers
Mike
'
I assume i would need to replace the pistons with meggy or williams ones and if i did it would i also require a new crank or would a 1.8 and 2.0 rank be the same?
Alot of you may think, just get a 2.0 engine - but this valver engine i have has only covered 30,000 miles and its mint, very tight and quick, quicker than my last valver, so i wanna keep this engine where possible.
Cheers
Mike
'