Allan
14-03-2007, 00:29
Right, when i did my bearing the other day i managed to pull out the drive shaft when pulling the hub assembly away from the shock, is this normal ???
i just pushed it back in and put the gater back on, and it was fine but should it come out like that ??
the part that came out had like a tripod on the end and was covered by a rubber gator this is after the point with what looked like a roll pin towards the diff end.
i just pushed it back in and put the gater back on, and it was fine but should it come out like that ??
the part that came out had like a tripod on the end and was covered by a rubber gator this is after the point with what looked like a roll pin towards the diff end.