My williams manifold

[dan 16v]

Did some work to my manifold today ready for it to be fitted start of next month.

Sanded it down last week.

Just sprayed it today.

Also wrapped it :)

Just need to cover it with the protective heat spray and its ready to go on!


Had a slight problem on the far left branch as the wrap decided to fray when I came to finish so had to lob some thicker wrap on to cover it up :oops: Apart from that all went well :)


Before wrap:

http://i123.photobucket.com/albums/o292/daniel_greenaway/Manifold/manifold.jpg
http://i123.photobucket.com/albums/o292/daniel_greenaway/Manifold/manifold1.jpg

After wrap drying infront of heater :)
http://i123.photobucket.com/albums/o292/daniel_greenaway/Manifold/manifold2.jpg
http://i123.photobucket.com/albums/o292/daniel_greenaway/Manifold/manifold4.jpg
http://i123.photobucket.com/albums/o292/daniel_greenaway/Manifold/manifold3.jpg

The wrap started black but after being in water most of it decided to come off all over my hands and the rag I was using to protect the carpet with!

[VIPERONE]

like mine..make sure you lt your car idle for a good 20 mins for the smoke off phase

[dan 16v]

like mine..make sure you lt your car idle for a good 20 mins for the smoke off phase

smoke off phase? Explain please?

[Hulio]

Its gonna smoke a bit when you start it up for the first time when you stick it back on.

[dan 16v]

I guessed that but why? :)

[16v_russ]

its exsess paint,and material like any solvents that is on there. nothin to worry about