View Full Version : RSi Gearbox on a Valver engine
Amirclio
04-01-2007, 18:57
Not that i dont trust Mr. Winston, just wanted to double check that i will have no problem fitting an RSi box (JB3) on my valver engine.
Cheers
Amir
:P
TBH ...I have never fitted one :wink:
But i was badly mocked for saying it wouldn't fit :oops:
cliolord
04-01-2007, 19:14
well....I removed my 16v engine (bass directs old engine) and it had a JB3 gearbox bolted to the side of it so...i would say yes :lol:
Amirclio
04-01-2007, 21:18
LOL No sweat winston! All cool then!
Cheers
Amir
clowo16v
04-01-2007, 22:42
You can only use the top engine to bellhousing bolts the bottom ones by the sump dont line up.
Matt
As above only fits properly if you swap the bell housing as teh RSi engine has a lower engine to gearbox tie bar instead of the bolts to teh sump, as the RSi's ahve a steel sump rather than an ali one
clowo16v
04-01-2007, 23:29
I have an Rsi one on my valver wi no probs tho
Matt
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.