Scorpion clio 1.8 16v full exhaust system (cat back)

[projectvalver]

Hardly used in good condition except for a few minor scratches and scrapes to centre section but does not affect performance

http://img139.imageshack.us/img139/5400/20061217image0021mj6.th.jpg (http://img139.imageshack.us/my.php?image=20061217image0021mj6.jpg)

http://img139.imageshack.us/img139/5215/20061217image0023ld8.th.jpg (http://img139.imageshack.us/my.php?image=20061217image0023ld8.jpg)

£125 collect only

[Mattie]

am i right in saying this would fit a williams from the cat back?

[edde]

am i right in saying this would fit a williams from the cat back?
Yep if you weld an extra bracket or two I forget.

To make it fit well the best idea isn't to buy it and buy a whole different exhaust.

One big problem is it sits to low the ways to fit it do exist dump the original heat matting and use some aftermarket stuff and make an extra mount at the back to lift it up just before the rear beam. the mid box is to big though to fit properly it sits to low.

[Mattie]

aye iv got a valver zorst on my williams atm and its really low!