PDA

View Full Version : power of williams turbo



thelynx
30-11-2006, 04:04
What power would you expect from a turbo willy lump
More asking if that they respond well to being turbo'ed

Bit of a guessing game I spose, lets say for arguements sake

Im not doin this, just wondered as you dont see many turboed clio's.. and if they are turbos there normally R5 gt lumps

Fully rebuilt 2.0
Worked head and cams
Low compression pistons 8.5,1
Steel H section rods and bolts
Decent intercooler (2wd cossie perhaps they are capable of handling 18psi)
Say 12psi boost
Managment who knows

2 live
30-11-2006, 08:44
adi s was the 1800 version, quite a high spec.....ex nick read car....he was plannin on runnin it up to close to 250 bhp ....apparently bb can do this....lol



unfortunately its just been sold again.........real nice lookin car, but the performance of it never really lived up to the amount of money spent imo.....beat it a few times down the strip, and had a few plays with it on road...same outcome really...far too much lag again imo.


doing the same to the williams lump..only ever seen 1 tbh..seen it a few times...unfortunately iv never seen it running or moving. reckon on this engine money would be better spent on other mods tbh. same as 1800.

northy
30-11-2006, 09:08
hes sold it ????

2 live
30-11-2006, 09:18
yes mate went a few weeks back

northy
30-11-2006, 09:21
Shame...did he make any on it ???

I have only seen 1.8 turbos run the 1/.4mile....think they were doing low 14's from memory on a poor day.

2 live
30-11-2006, 09:53
well last time i ran against nicks...while he had it...was at usc pod couple years ago.raced him 3 times..got the better of him twice....35 degree heat...an i was runnin sloooooooow lol...mid 14s iirc.


startline had that much glue shit on it.was launchin at double rpm than normal..and still boggin down off the line..was dire tbh.

tony16v
30-11-2006, 12:03
I think BB use a T28 turbo, I have a T25 on mine which is smaller so spools up quicker and is still good for 15psi.

REN GT
30-11-2006, 14:49
is there an upraited rad for the turbo conversion or is the original rad good enough

tony16v
30-11-2006, 14:53
no need, I've not had any problems and I got the std rad... but I have got a seperate oil cooler as well.

jamesy
01-12-2006, 09:00
so do i,seperate small rad mounted just in front of the original.

MAXIBOY
02-12-2006, 01:23
over 350bhp but the chassis is the weak point then. plus the gearbox needs serious work. bb had 378bhp out of one of theres

2 live
02-12-2006, 14:22
for abvout 20 secs yeah.then it blew up........like most the others theyv done lol.