Piper
21-11-2006, 20:37
I'm looking to run a cold air feed to by air box from the near side blanking plate. Easy to do!
But I was also thinking of running a second feed from the off side blanking plate. As any one tryed this ?
The route looks a little tight running under the inlet manifold, between the engine and the rad. But I thought it would be a good idea to increase air flow and also balnace up the look on the bumper with two ducts rather than one.
Any thoughts :roll:
But I was also thinking of running a second feed from the off side blanking plate. As any one tryed this ?
The route looks a little tight running under the inlet manifold, between the engine and the rad. But I thought it would be a good idea to increase air flow and also balnace up the look on the bumper with two ducts rather than one.
Any thoughts :roll: