Dash bulbs

[vts_saxo]

I am currently trying to change a dash bulb which blew, i have taken off every screw in sight but still can not see how the dash binical comes out?? I have taken off the bit of trim which goes round the stalks and un done the two screw which look to be directly under the dials, please help is there a guide on this site?

Cant believe i cant change a bulb :sopping:

[MatBrown]

Have you taken the top dash off and undone the 2 screws under there?



Mat.

[BristolSam16v]

Top dash off, 2 screws holding dials in at the top and two screws holding it in at the bottom.

Have you done the top 2?

[vts_saxo]

Thanks for quick replys, yes the top black bit of dash is removed and the 2 screws at the top of dials have been removed.

Could it just need a push and pull to free it?

[Laine_16v]

Thanks for quick replys, yes the top black bit of dash is removed and the 2 screws at the top of dials have been removed.

Could it just need a push and pull to free it?

Have you done the bottom 2 though?

[vts_saxo]

Thanks for quick replys, yes the top black bit of dash is removed and the 2 screws at the top of dials have been removed.

Could it just need a push and pull to free it?

Have you done the bottom 2 though?

yip

[MatBrown]

If you have got the 4 screws out that hold it in place, you just need to tilt the top forward and pull it upwards, you will need to slide your hand round the back to release the speedo cable.



Mat.

[BristolSam16v]

As matt says, it should be loose but the speedo cable is quite tight so ull have to squeeze ure hand round the back to pinch it out

[vts_saxo]

Ok it should be ready, ill try it now.

Thanks guys