PDA

View Full Version : conversion



lumoxs
29-10-2006, 23:38
how hard would it be to convert the williams wide track to a valver?

just asking outta curisoty (sp) and has anyone done it?

richy
29-10-2006, 23:40
just need shockers/wishbones/shafts/arb and bushes and just wind the trackrods out

Coops
29-10-2006, 23:40
been done loads mate

u need williams driveshafts, bottom arms and struts. can use valver hubs and subframe and just wind track rod ends out to fit the wider track. job done! 8)

Coops
29-10-2006, 23:41
just need shockers/wishbones/shafts/arb and bushes and just wind the trackrods out

oh ah, and the arb! :oops: :wink:

lumoxs
29-10-2006, 23:45
is it a hard job to do then?

Coops
29-10-2006, 23:48
half a day if u know what ur doing
only real stickin point is gettin the roll pins out the driveshafts as they can be a git!oh and gettin it tracked after! 8)

lumoxs
29-10-2006, 23:51
could be something to think about! is the handling that much better than the valver then?

Coops
29-10-2006, 23:55
http://www.williamsclio.co.uk/forum/viewtopic.php?t=15915

:wink:

lumoxs
30-10-2006, 00:02
DOH knew i shoulda searched - cheers fella!