View Full Version : conversion
how hard would it be to convert the williams wide track to a valver?
just asking outta curisoty (sp) and has anyone done it?
just need shockers/wishbones/shafts/arb and bushes and just wind the trackrods out
been done loads mate
u need williams driveshafts, bottom arms and struts. can use valver hubs and subframe and just wind track rod ends out to fit the wider track. job done! 8)
just need shockers/wishbones/shafts/arb and bushes and just wind the trackrods out
oh ah, and the arb! :oops: :wink:
is it a hard job to do then?
half a day if u know what ur doing
only real stickin point is gettin the roll pins out the driveshafts as they can be a git!oh and gettin it tracked after! 8)
could be something to think about! is the handling that much better than the valver then?
http://www.williamsclio.co.uk/forum/viewtopic.php?t=15915
:wink:
DOH knew i shoulda searched - cheers fella!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.