Help !!!!

[cliorod]

Anyone on here,that can help me please.I am having some special steel driveshafts made for the rally car :lol: ~~~ thing is,it uses a short passenger side shaft ~~ needed because of the ZF LSD. :oops:

Thing is,it fits currently in the rally car,which has the narrow valver bottom arms and works ok,however,the rose jointed fully adjustable arms I have had made are Williams width :P .
SO ~~~ Question ~~~ what is the exact difference in length,between a a 16v drive shaft and a Williams one ~~~ need to know the exact length of each,etc within 0,25mm please.
Will save me rumaging around and getting shafts etc to measure.
Thanks in anticipation. :wink:

[Lunner]

i have valver shafts in the garage, but haven't got the kit to measure them that accuratly

[cliorod]

Many thanks for the offer Lunner :wink:
However,I have discovered in my parts store a Williams and Valver bottom arms,so the difference between these will be the same as difference as the shafts :roll: :roll: :roll: .I hope :oops: :lol: :oops:

[Lunner]

worth noting that the bushes in the williams wishbone are bigger than the valver ones